High speed cutting machine points to the common quality problems

In the process of high-speed cutting machine cutting common quality problems:

1, vertical stripes

Main show is refers to the roller surface ring rib to linear stripe. In high-speed cutting machine in the process of cutting and winding air into the poor and cumulative thickness tolerance is the main cause of longitudinal stripe, once appear more severe degree of stripes is difficult to eliminate.

2, wrong layer,

Refers to the roller face some film fault phenomenon, the problem is mainly film in the winding process caused by sliding or film width change.

3, wrinkles

This kind of problem only occurred in the film winding began a length, main show is wrinkled and stripe dolly, the reasons are caused by many factors.

4, become warped edge

Is the quality problem occurs at the edge of the film winding position, the thick film edge is tilted by the winding stack edge areas.

5, critical reinforcement

The quality problem is due to the thick film thickness tolerances accumulated in roller surface obviously swelled.

6 insufficient, length, width, thought too much

The quality problem is due to winding counting errors or by cutting film length and equipment position is not right to wait for a reason.

High speed cutting machine use 4 points that should be paid attention to